* Arnd Bergmann <[email protected]> [140429 13:35]:
> On Tuesday 29 April 2014 15:19:47 Dan Murphy wrote:
> > + * AM33xx reset index for PRCM Module
> > + *
> > + * Copyright 2014 Texas Instruments Inc.
> > + *
> > + * This program is free software; you can redistribute it and/or modify
> > + * it under the terms of the GNU General Public License version 2 as
> > + * published by the Free Software Foundation.
> > + */
> > +
> > +#ifndef _DT_BINDINGS_RESET_TI_AM33XX_H
> > +#define _DT_BINDINGS_RESET_TI_AM33XX_H
> > +
> > +#define RESET_DEVICE_RESET 0
> > +#define RESET_GFX_RESET 1
> > +#define RESET_PER_RESET 2
> > +
> > +#endif
>
> Interfaces like this should only be used if you can't use hardware
> numbers, in general. If these numbers are in the data sheet, just
> put them directly into the dts file, as we do for interrupt numbers,
> gpio numbers, register offsets etc.
>
> If you have made them up to define an interface between the driver
> and DT because there is no usable hardare ID, I'd suggest just using
> a single file across all SoCs that have this driver, and have
> a unified name space.
Also, it's a bit unclear how the reset controller phandle is used
referenced and used by the consumer device.. Maybe setting that up
first in a Linux generic way is a good point starting point.
Maybe something like this along the same way as clocks are set up
(completely untested):
&reset1 {
iva_reset: reset1 {
reg = /bits/ 8 <0>;
};
gfx_reset: reset1 {
reg = /bits/ 8 <1>;
};
...
};
&iva {
compatible = "ti,ivahd";
resets = <&reset1 1>;
...
};
Regards,
Tony
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
