On Wed, Jun 25, 2014 at 08:54:01PM +0100, Robert Jarzmik wrote:
> Mark Rutland <[email protected]> writes:
>
> > On Sun, Jun 22, 2014 at 10:04:58AM +0100, Robert Jarzmik wrote:
> >> index 79729a9..0e4863f 100644
> >> --- a/Documentation/devicetree/bindings/usb/pxa-usb.txt
> >> +++ b/Documentation/devicetree/bindings/usb/pxa-usb.txt
> >> @@ -29,3 +29,23 @@ Example:
> >> marvell,port-mode = <2>; /* PMM_GLOBAL_MODE */
> >> };
> >>
> >> +UDC
> >> +
> >> +Required properties:
> >> + - compatible: Should be "marvell,pxa27x-udc" for USB controllers
> >> + used in device mode.
> >
> > We typically don't like wildcard compatible strings in DT.
> Same as in the other patch, "marvell,pxa270-udc".
> >
> >> +
> >> +Optional properties:
> >> + - "udc-pullup-gpio" - gpio activated to control the USB D+ pullup.
> >> + - "udc-pullup-gpio-inverted" - boolean inverting gpio pullup logic.
> >
> > Use the GPIO bindings.
> OK. I'm presuming in this case you think of something like :
> udc-pullup-gpio = <&gpio 22 GPIO_ACTIVE_LOW>
> Which translates into:
> "udc-pullup-gpio" - gpio activated to control the USB D+ pullup (see
> gpio.txt)
Something like that, yes.
> >
> >> +
> >> +Example:
> >> +
> >> + pxa27x_udc: udc@40600000 {
> >> + compatible = "marvell,pxa27x-udc";
> >> + reg = <0x40600000 0x10000>;
> >> + interrupts = <11>;
> >> + clocks = <&pxa2xx_clks 11>;
> >> + clock-names = "pxa27x-udc";
> >
> > Neither of these were mentioned above.
> Ah you mean I shall describe the standard reg, interrupts as mandatory
> standard
> options I take it. OK.
Yes. While the properties are standard, their precise meanings (e.g.
which interrupt or address space region), and whether a particular
binding uses them is not.
> > The name of the clock input doesn't make sense.
> I don't understand. With [1] does it make any more sense ? If not you'll have
> to
> expand a bit more the "doesn't make sense".
My concern is that clock-names is supposed to describe the name of the
input clock line from the view of the IP block. "pxa27x-udc" doesn't
sound like the name of a clock input line from the view of the UDC
block.
I assume the clock input line you care about has a more specific name
than "pxa27x-udc"?
Cheers,
Mark.
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
