Cc: [email protected]
Cc: Srinivas Kandagatla <[email protected]>
Acked-by: Alexandre Torgue <[email protected]>
Signed-off-by: Lee Jones <[email protected]>
---
Hi Tejun,
This patch has been on the MLs for a few months now. It documents
ST's AHCI driver which was accepted by you and now resides in
Mainline.
Kind regards,
Lee
Documentation/devicetree/bindings/ata/ahci-st.txt | 31 +++++++++++++++++++++++
1 file changed, 31 insertions(+)
create mode 100644 Documentation/devicetree/bindings/ata/ahci-st.txt
diff --git a/Documentation/devicetree/bindings/ata/ahci-st.txt
b/Documentation/devicetree/bindings/ata/ahci-st.txt
new file mode 100644
index 0000000..0574a77
--- /dev/null
+++ b/Documentation/devicetree/bindings/ata/ahci-st.txt
@@ -0,0 +1,31 @@
+STMicroelectronics STi SATA controller
+
+This binding describes a SATA device.
+
+Required properties:
+ - compatible : Must be "st,sti-ahci"
+ - reg : Physical base addresses and length of register sets
+ - interrupts : Interrupt associated with the SATA device
+ - interrupt-names : Associated name must be; "hostc"
+ - resets : The power-down and soft-reset lines of SATA IP
+ - reset-names : Associated names must be; "pwr-dwn" and "sw-rst"
+ - clocks : The phandle for the clock
+ - clock-names : Associated name must be; "ahci_clk"
+ - phys : The phandle for the PHY device
+ - phy-names : Associated name must be; "ahci_phy"
+
+Example:
+
+ sata0: sata@fe380000 {
+ compatible = "st,sti-ahci";
+ reg = <0xfe380000 0x1000>;
+ interrupts = <GIC_SPI 157 IRQ_TYPE_NONE>;
+ interrupt-names = "hostc";
+ phys = <&miphy365x_phy MIPHY_PORT_0 MIPHY_TYPE_SATA>;
+ phy-names = "ahci_phy";
+ resets = <&powerdown STIH416_SATA0_POWERDOWN>,
+ <&softreset STIH416_SATA0_SOFTRESET>;
+ reset-names = "pwr-dwn", "sw-rst";
+ clocks = <&clk_s_a0_ls CLK_ICN_REG>;
+ clock-names = "ahci_clk";
+ };
--
1.8.3.2
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
