On this EVM, the USB cable state has to be determined via the ID pin tied to a GPIO line. We use the gpio-usb-extcon driver to read the ID pin and the extcon framework to forward the USB cable state information to the USB driver so the controller can be configured in the right mode (host/peripheral).
Gets USB peripheral mode to work on this EVM. Signed-off-by: Roger Quadros <[email protected]> Reviewed-by: Felipe Balbi <[email protected]> Acked-by: Felipe Balbi <[email protected]> --- arch/arm/boot/dts/dra7-evm.dts | 31 +++++++++++++++++++++++++++++++ 1 file changed, 31 insertions(+) diff --git a/arch/arm/boot/dts/dra7-evm.dts b/arch/arm/boot/dts/dra7-evm.dts index ad4118f..746cddb 100644 --- a/arch/arm/boot/dts/dra7-evm.dts +++ b/arch/arm/boot/dts/dra7-evm.dts @@ -26,6 +26,16 @@ regulator-max-microvolt = <3300000>; }; + extcon_usb1: extcon_usb1 { + compatible = "linux,extcon-usb-gpio"; + id-gpio = <&pcf_gpio_21 1 GPIO_ACTIVE_HIGH>; + }; + + extcon_usb2: extcon_usb2 { + compatible = "linux,extcon-usb-gpio"; + id-gpio = <&pcf_gpio_21 2 GPIO_ACTIVE_HIGH>; + }; + vtt_fixed: fixedregulator-vtt { compatible = "regulator-fixed"; regulator-name = "vtt_fixed"; @@ -391,6 +401,19 @@ }; }; }; + + pcf_gpio_21: gpio@21 { + compatible = "ti,pcf8575"; + reg = <0x21>; + lines-initial-states = <0x1408>; + gpio-controller; + #gpio-cells = <2>; + interrupt-parent = <&gpio6>; + interrupts = <11 IRQ_TYPE_EDGE_FALLING>; + interrupt-controller; + #interrupt-cells = <2>; + }; + }; &i2c2 { @@ -520,6 +543,14 @@ }; }; +&omap_dwc3_1 { + extcon = <&extcon_usb1>; +}; + +&omap_dwc3_2 { + extcon = <&extcon_usb2>; +}; + &usb1 { dr_mode = "peripheral"; pinctrl-names = "default"; -- 2.1.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
