On 05.10.2015 22:35, Bartlomiej Zolnierkiewicz wrote: > > Hi, > > On Friday, October 02, 2015 05:25:51 PM Krzysztof Kozlowski wrote: >> The WRSTBI bit (disabled by default but enabled by bootloader), when >> set, is responsible for resetting voltages to default values of >> certain bucks on falling edge of Warm Reset Input pin from AP. >> >> However on some boards (with S2MPS13) the pin is pulled down so any >> suspend will effectively trigger the reset of bucks supplying the power >> to the little and big cores. In the same time when resuming, these bucks >> must provide voltage greater or equal to voltage before suspend to match >> the frequency chosen by cpufreq. If voltage (default value of voltage >> after reset) is lower than one set by cpufreq before suspend, then >> system will hang during resuming. >> >> Signed-off-by: Krzysztof Kozlowski <[email protected]> > > I tested this (with some additional Exynos5433 patches) and it works > like expected (suspend/resume issue is fixed). > > Tested-by: Bartlomiej Zolnierkiewicz <[email protected]> >
Thanks! > You could also add: > > Reported-by: Bartlomiej Zolnierkiewicz <[email protected]> > > (since the issue got narrowed down and reported to you by me :). I didn't put it because I wasn't sure who was the author of our report. I'll wait a one more day for any comments and add it in v2/resend. BTW, any comments on the binding itself? Actually I had hard time choosing the name for binding because unlike the ACOKB the WRSTBI pin is not grounded but pulled down. However it is quite similar so I stick to the same convention: - samsung,s2mps11-acokb-ground - samsung,s2mps11-wrstbi-ground Best regards, Krzysztof -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
