On Thu, Dec 03, 2015 at 04:51:31PM +0100, Wolfram Sang wrote: > From: Wolfram Sang <[email protected]> > > Also, sort the properties alphabetically and make indentation > consistent. Wording largely taken from i2c-rk3x.txt, thanks guys! > > Only "i2c-scl-internal-delay-ns" is new, the rest is used by two drivers > already and was documented in their driver binding documentation. > > Signed-off-by: Wolfram Sang <[email protected]> > Cc: [email protected]
Acked-by: Rob Herring <[email protected]> > --- > Documentation/devicetree/bindings/i2c/i2c.txt | 31 > ++++++++++++++++++++++----- > 1 file changed, 26 insertions(+), 5 deletions(-) > > diff --git a/Documentation/devicetree/bindings/i2c/i2c.txt > b/Documentation/devicetree/bindings/i2c/i2c.txt > index 8a99150ac3a7fd..a00219f5ee0733 100644 > --- a/Documentation/devicetree/bindings/i2c/i2c.txt > +++ b/Documentation/devicetree/bindings/i2c/i2c.txt > @@ -29,12 +29,33 @@ Optional properties > These properties may not be supported by all drivers. However, if a driver > wants to support one of the below features, it should adapt the bindings > below. > > -- clock-frequency - frequency of bus clock in Hz. > -- wakeup-source - device can be used as a wakeup source. > +- clock-frequency > + frequency of bus clock in Hz. > > -- interrupts - interrupts used by the device. > -- interrupt-names - "irq" and "wakeup" names are recognized by I2C core, > - other names are left to individual drivers. > +- i2c-scl-falling-time-ns > + Number of nanoseconds the SCL signal takes to fall; t(f) in the I2C > + specification. > + > +- i2c-scl-internal-delay-ns > + Number of nanoseconds the IP core additionally needs to setup SCL. > + > +- i2c-scl-rising-time-ns > + Number of nanoseconds the SCL signal takes to rise; t(r) in the I2C > + specification. > + > +- i2c-sda-falling-time-ns > + Number of nanoseconds the SDA signal takes to fall; t(f) in the I2C > + specification. > + > +- interrupts > + interrupts used by the device. > + > +- interrupt-names > + "irq" and "wakeup" names are recognized by I2C core, other names are > + left to individual drivers. > + > +- wakeup-source > + device can be used as a wakeup source. > > Binding may contain optional "interrupts" property, describing interrupts > used by the device. I2C core will assign "irq" interrupt (or the very first > -- > 2.1.4 > > -- > To unsubscribe from this list: send the line "unsubscribe devicetree" in > the body of a message to [email protected] > More majordomo info at http://vger.kernel.org/majordomo-info.html -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
