Some boards connect the LCD_RESET pin to a reset input on the display panel. On these boards, this pin must be set to the proper level for the display to function.
This adds an optional "reset-active" property to the "display" subnode such that devicetrees can specify the desired polarity of the LCD_RESET pin. Signed-off-by: Mans Rullgard <[email protected]> --- Documentation/devicetree/bindings/display/mxsfb.txt | 5 +++++ 1 file changed, 5 insertions(+) diff --git a/Documentation/devicetree/bindings/display/mxsfb.txt b/Documentation/devicetree/bindings/display/mxsfb.txt index 96ec517..cb7212a 100644 --- a/Documentation/devicetree/bindings/display/mxsfb.txt +++ b/Documentation/devicetree/bindings/display/mxsfb.txt @@ -13,6 +13,11 @@ Required properties: - bits-per-pixel : <16> for RGB565, <32> for RGB888/666. - bus-width : number of data lines. Could be <8>, <16>, <18> or <24>. +Optional properties: +- reset-active : <0>: reset pin is active low + <1>: reset pin is active high + omitted: reset pin not used + Required sub-node: - display-timings : Refer to binding doc display-timing.txt for details. -- 2.6.3 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
