--- In [email protected], "mac2251" <[EMAIL PROTECTED]> wrote: > > I purchased a new HP computer and installed MixW and N1MM logger. > The CAT works fine and the receive is fine but no transmit. Speakers > connected to my outboard sound card have transmit tones but the 746 > shows no power out. I have tried all the settings I can think of but > nothing works. It was working fine on the old antique :( Any one > have any ideas. Thanks...Mike K9HCK >
Is it a laptop or desktop PC? Some laptops, and an occasional desktop have soundcards that provide insuffient audio levels, not enough to drive the rig. I have helped solve this for a couple of people by taking the PC's audio to a amplified system of sorts, one where you can slowly raise the volume of the audio getting to the rig. Keep the audio levels as low as possible and slowly raise it, see if the rigs output rises. That has worked a few times, just enough to find out what the problem was, or wasn't. Then they got new sounds cards with more output. Of course it coule be a 746 setting but I know nothing about that radio. Oh, did you check your cable leading from soundcard to rig? I have heard of a few cases where, after hours of trying the "obvious" they found it to be simply a bad cable connector. Also, is there a different device setting you can try? I had one software application that for some odd reason had much lower audio output if I chose the device setting for my actual sound card. Instead, "default device " worked better. Andy K3UK Need a Digital mode QSO? Connect to Telnet://cluster.dynalias.org Other areas of interest: The MixW Reflector : http://groups.yahoo.com/group/themixwgroup/ DigiPol: http://groups.yahoo.com/group/Digipol (band plan policy discussion) Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/digitalradio/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
