Rick,
 
You have to MUTE the incoming audio (as strange as that sounds) and make sure the playback volume is up so you can hear the decoded signal.
 
Once the signal is decoded, it will playback through your PC speakers. We use two sound cards here (Laptop card and mini USB card).
 
One transmits the WinDRM signal and takes in the PC mic audio and the other receives the WinDRM signal (mic or line input) and plays it back through your pc speakers.
 
Have no experience with a single sound card.
 
Tony KT2Q
 
----- Original Message -----
From: KV9U
Sent: Tuesday, October 24, 2006 8:48 PM
Subject: Re: [digitalradio] QRV DV 2300z

How do you set up the mike level? I have tried various approaches and I
am not sure it is working. If you set the display for "input level"
should that show the mike input? Or is there some other display setting
for that?

And then to adjust the mike, which control do you use? The "recording"
mike input?

But then if you do that with one sound card, would not that mean you do
not have a line "recording" which you must need for inputting the audio
from the rig to decode the DRM data because you can not run both
simultaneously?

Or do you control the mike on the output or "playback" side?

73,

Rick, KV9U

Andrew O'Brien wrote:

>To transmit DV, you press TX VOICE in the WinDRM software AND speak in to
>the PC's microphone at the same time.
>
>Andy K3UK
>
>
>

__._,_.___

Need a Digital mode QSO? Connect to  Telnet://cluster.dynalias.org

Other areas of interest:

The MixW Reflector : http://groups.yahoo.com/group/themixwgroup/
DigiPol: http://groups.yahoo.com/group/Digipol  (band plan policy discussion)






SPONSORED LINKS
Ham radio Ham radio antenna Ham radio store
Digital voice Digital voice recorder mp3

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___

Reply via email to