A 746Pro can be switched between RX and TX via CI-V commands. I don't use MixW, but wonder if your friend has it configured properly.
73, Dave, AA6YQ --- In digitalradio@yahoogroups.com, "Andrew O'Brien" <[EMAIL PROTECTED]> wrote: > > So RIck, is this the same for Icom and Mixw? I have a friend that > can;t get MixW to do both rig control and PTT with his 746 Pro but can > get Commander /MUltipsk to do it. > > For WinDRM though, there is NO CW...just PTT. > > Andy. > > On 1/4/07, KV9U <[EMAIL PROTECTED]> wrote: > > When you use DTR for CW and PTT with RTS, how does an interface such as > > Rigblaster handle this with the COM ports? > > > > You must need to connect a COM port to each of them, right? > > > > If you have only one COM port available you can either key CW or key > > PTT, but not both. And if you need rig control, that would require yet > > another COM port. > > > > Most computers no longer have COM ports so I purchased one USB to COM > > port adapter. This goes to my homebrew COM port to CI-V port converter. > > The CI-V can control most of the radio functions, including PTT. > > Unfortunately, it can not control CW keying, nor FSK keying and that > > would require additional COM ports (or USB to COM port adapters) for > > each one. > > > > Since there are programs that support CI-V control, such as DX Commander > > which, in turn, supports Multipsk, and gives you just about every sound > > card mode and a few that are not available on any other software, I have > > not been very interested in trying to adapt to programs that do not have > > this capability. > > > > 73, > > > > Rick, KV9U > > > > > > > > Andrew O'Brien wrote: > > > > > Are you using a Rigblaster pro, plus, or plug and play ? I found this > > > reference, not sure if it helps. > > > > > > > > > *RIGblaster plug & play Operational Details:* > > > > > > *CW keying is done by setting DTR high on the emulated serial port. * > > > *Standard PTT is done by setting RTS high on the emulated serial port. > > > > > > The Icom IC-746 and similar radios use pin 6 on the 7 pin DIN ACC(2) jack > > > for PTT on the 2 meter band. Since the adapter only connects to the 8 pin > > > DIN ACC(1) jack, the RIGblaster plug & play cannot use standard PTT > > > keying > > > for the 2 meter band. One solution is to use CAT control for transmit and > > > receive with the built-in CI-V interface* > > > ** > > > ** > > > ** > > > > > > > > > > Announce your digital presence via our DX Cluster telnet://cluster.dynalias.org > > > > Our other groups: > > > > http://groups.yahoo.com/group/dxlist/ > > http://groups.yahoo.com/group/themixwgroup > > http://groups.yahoo.com/group/contesting > > http://groups.yahoo.com/group/wnyar > > http://groups.yahoo.com/group/Omnibus97 > > > > > > Yahoo! Groups Links > > > > > > > > > > > -- > Andy K3UK > Skype Me : callto://andyobrien73 > www.obriensweb.com >