Hello Andy, thank you for getting back to me. Ok, I think I'm starting to get the idea. I can't cut and paste the text from the DOS window, but could certainly post a screen shot of it. But in summary here is what I've got:
First I have an error reading wsjt.ini and continuuing with defaults. Next I have a message ID Interval 10 This sequence is repeated a second time. Then I have a message "Using PortAudio" followed by a table. I am not sure how this table will come accross in this message but here is a try: Audio Device Input Output Name 0 2 0 Micorsoft Sound Mapper-Input 1 2 0 Realtec HD Audio Rear Input 2 1 0 Modem #2 Line Record 3 2 0 USB Audio Codec 4 0 2 Microsoft Sound Mapper Output 5 0 2 Realtec HD Audio rear output 6 0 1 Modem #2 Line Playback 7 0 2 USB Audio CODEC Default Input:0 Output:4 Requested Input:0 Output:0 Opening devise 0 for input, 4 for output. Audio streams running normally. I need to point out that the Realtec is the internal sound card and the USB Audio Codec is the SignaLink sound card. I hope this will be able to help you point me in the right direction. Thank you, 73 de KC9HEK Brian --- In digitalradio@yahoogroups.com, "Andrew O'Brien" <[EMAIL PROTECTED]> wrote: > > In the WSJT dos-type window that boots up, what do your device settings say > ? > > > > On 10/28/07, Brian <[EMAIL PROTECTED]> wrote: > > > > Good afternoon folks, > > > > I have recently downloaded the WSTJ software for use with JT65. I > > have also read the very well done Bozo's Guide. (Thank you.) That > > said, I am unable to get the software configured properly. > > > > I have been running the more common digital modes for almost two > > years. I rountinly uses MultiPSK and DM780 using my existing > > configuration. Basically, I have HRD deluxe connected to my TS- 2000 > > on Com Port 1. I have the SignaLink USB connected to the 13 pin Aux > > on the TS-2000. In both DM780 and MultiPSK the sound card inititates > > the transmit signal. > > > > In both of these other softwares, I can also choose which sound card > > to use and have identified the SignaLink as the appropriate sound > > card. > > > > When trying to get WSTJ to run, I have gone into my Audio Properties > > (Windows XP PRO) and have made the SignaLink my default sound card > > with no success. > > > > I suspect my setup isn't all that uncommon and that I am missing > > something very simple and obvious. If someone could help me out, it > > would be most appreciated. > > > > Thank you in advance, > > > > 73 de KC9HEK > > Brian > > > > > > > > > > -- > Andy K3UK > www.obriensweb.com > (QSL via N2RJ) >