I'm having problems with 50hz Pal TV, I lose like 20-30px from all sides
when using df_xine or dfbsee, is there any way to adjust the picture?
I've been messing around with fbset -left -right -upper -lower, but they
don't seem to help with this problem...
mode "736x576-84"
# D: 49.498 MHz, H: 58.926 kHz, V: 84.180 Hz
geometry 736 576 736 576 32
timings 20203 50 50 60 60 4 4
vsync high
bcast true
accel true
rgba 8/16,8/8,8/0,8/24
endmode
My last mode was 720x576, and that didn't work either.
---- clip system data ----
graphics card: Matrox G400 DH
DirectFB:directfb-config --version = 0.9.25
dfb screen info:
Screen (00) FBDev Primary Screen (primary screen)
Caps: VSYNC POWER_MANAGEMENT
Layer (01) FBDev Primary Layer
Type: GRAPHICS
Caps: SURFACE BRIGHTNESS CONTRAST SATURATION
Layer (00) Matrox Backend Scaler (primary layer)
Type: GRAPHICS VIDEO STILL_PICTURE
Caps: SURFACE SCREEN_LOCATION DEINTERLACING DST_COLORKEY
BRIGHTNESS CONTRAST SCREEN_POSITION SCREEN_SIZE
Screen (01) Matrox CRTC2 Screen
Caps: VSYNC ENCODERS OUTPUTS
Encoder (0)
Type: TV
Caps: TV_STANDARDS
TV Standards: PAL NTSC
Output (0)
Caps: CONNECTORS SIGNAL_SEL CONNECTOR_SEL
Connectors: SCART YC CVBS
Signals: YC CVBS RGB
Layer (02) Matrox CRTC2 Layer
Type: GRAPHICS VIDEO STILL_PICTURE
Caps: SURFACE BRIGHTNESS CONTRAST HUE SATURATION FIELD_PARITY
ALPHA_RAMP
Layer (03) Matrox CRTC2 Sub-Picture
Type: GRAPHICS VIDEO STILL_PICTURE
Caps: SURFACE OPACITY ALPHACHANNEL
directfbrc:
depth=32
primary-layer=1
matrox-crtc2
matrox-cable-type=composite
matrox-sgram
fbdev=/dev/fb0
no-vt-switch
_______________________________________________
directfb-users mailing list
[email protected]
http://mail.directfb.org/cgi-bin/mailman/listinfo/directfb-users
