On Thu, Mar 30, 2006 at 06:33:03AM -0800, seph 004 wrote: > Hi > > I am struggling at the moment to get the USB to my USRP board working again. > When I try to run any programs, it returns with > > usrp: failed to find usrp[0] > > My dmesg output looks like this when I connect my USRP: > > usb 3-2: new high speed USB device using ehci_hcd and address 6 > usb 3-2: unable to read config index 0 descriptor/all > usb 3-2: can't read configurations, error -71 > usb 3-2: new high speed USB device using ehci_hcd and address 7 > usb 3-2: device not accepting address 7, error -71 > usb 3-2: new high speed USB device using ehci_hcd and address 8 > usb 3-2: unable to read config index 0 descriptor/all > usb 3-2: can't read configurations, error -75 > usb 3-2: new high speed USB device using ehci_hcd and address 9 > usb 3-2: device descriptor read/8, error -71 > usb 3-2: device descriptor read/8, error -71 > usb 3-2: new high speed USB device using ehci_hcd and address 10 > usb 3-2: unable to read config index 0 descriptor/all > usb 3-2: can't read configurations, error -71 > usb 3-2: new high speed USB device using ehci_hcd and address 11 > usb 3-2: device descriptor read/all, error -71 > usb 3-2: new high speed USB device using ehci_hcd and address 12 > usb 3-2: can't set config #1, error -71 > > I don't understand what is happening, because it was happily working not too > long ago. I am using the 2.6.15-1-686 kernel. I have no problems mounting my > flash drive using the same ports. Also, I can load the firmware via the > USB1.1 ports, so I don't think there is anything wrong with the USRP. I am > not that familiar with Linux, and I am really stuck at the moment. Any help > would be greatly appreciated. > > Regards > > Lance
Sorry, no clue. Eric _______________________________________________ Discuss-gnuradio mailing list [email protected] http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
