John Stralka wrote:
> I reinstalled the trunk version of GNU Radio, and I was able to successfully
> burn the RFX 2400 to MIMO A. The problem I have now is that I cannot seem to
> get the daughterboard to tune on receive in either a Rev 3 USRP or a Rev 4
> USRP. I've verified that it is reporting MIMO A in the USRP Diagnostics
> within GRC, but when I run usrp_fft.py on the MIMO A board, I get "Failed to
> set initial frequency".
>
> I tried putting at MIMO A (side B) and a MIMO B (side A) RFX 2400 in a
> single Rev 4 USRP. Interestingly, I am able to transmit a tone via a MIMO A
> card and receive it in a MIMO B card. But I cannot receive the tone
> transmitted by the MIMO B card on the MIMO A card due to this "Failed to set
> initial frequency" problem. The MIMO B board's tone is fine. This is how I
> was testing them.
> ./usrp_fft.py -R B -d 256 -f 2.4375e9 -g 10 & ./usrp_siggen.py -f
> 2.437550e9 -i 512 --const -T A
>
> When I burned the MIMO A card, I used the following command:
> ./usrp/host/apps/burn-db-eeprom -f -A -t rfx2400_mimo_a
>
> Is there something I should check? I'm at a loss on how to proceed. Any
> suggestions would be appreciated. Thank you.
>
First off, reburning the eeprom is the LAST step in a several step
process to make an RFX board into a MIMO_A board. The rest of the
procedure is shown here:
http://gnuradio.org/trac/wiki/USRPClockingNotes
Secondly, why are you doing this? You have MIMO_B boards which is the
optimal setup. The only reason to make a mimo_a board is if you want to
use it with a very old rev 3 USRP, which you do not have.
Matt
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
