Eric Blossom wrote:
On Wed, Dec 12, 2007 at 04:58:36PM -0500, [EMAIL PROTECTED] wrote:
I installed kernel of 2.6.24-rc4-gd7f0b481 for Fedora 7 in PS3 following
http://www.gnuradio.org/trac/wiki/PS3FC7Install.
The linux system runs well. Then I installed GNU radio as told in above URL.
Everything went well too. However, I could not get USRP work. I am not sure
whether it is because of the new kernel or something else. Therefore, I listed
the test script and output below for running usrp_benchmark_usb.py and also the
output from dmesg to test USB connection.
Your help will be very appreciated!
Andrew Ge
Did you setup udev as the wiki page instructed?
Are you in group usrp?
Eric
Eric,
I strictly followed the setup udev as the wiki page:
http://www.gnuradio.org/trac/wiki/UdevConfig. However, because the new
kernel 2.6.24-rc4-gd7f0b481uses different sysfs from previous kernel, (I
browsed through google to get this information), I can't examine
/dev/bus/usb after plugging in a USRP simply by the command
$ ls -lR /dev/bus/usb
That's why I listed dmesg result to give more information about USRP
connection.
On the other hand, I assume the above instruction is used for allowing
non-root users to access the USRP. I tried root to run
./usrp_benchmark_usb.py
I also tried non-root user within the group usrp. Both results are
same as I showed in the previous email.
Thanks,
Andrew
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
