Hi, I have been intensely bothering the forum with my USRP problems, and hope to solve them one day:) I have tried the command usrper led1 on and get;
usrper: found unconfigured usrp; needs firmware. usb_control_msg failed: error sending control message: Connection timed out usrper: failed I dont know why this firmware is not loaded correctly but after searching the forum a little bit for those who experienced similar kind of problems, I found this command for loading the firmware usrper load_firmware /opt/gnuradio/share/usrp/rev4/std.ihx ( although I think if everything goes right there shouldnt be a neccassity for this command anyway) but what I get after this command is again; usrper: found unconfigured usrp; needs firmware. If I am unable to load the firmware manually, what is so wrong with my system? As I have said earlier I think I don't have any problem with my GNU Radio software since I made the dial tone example work. There cannot be a problem with the USB version since I am using the high speed USB2.0 connection. The only thing that comes into my mind and also from the replies that I get for my earlier messages is the bad USB cable but I also dont think that is the problem either. Interestingly the blinking led goes OFF after executing these commands both the usrper led1 on and usrper load_firmware /opt/gnuradio/share/usrp/rev4/std.ihx , I have seen some people reported to forum similar experiences with this LED remaning ON or OFF. This shows that I have some communication with the board but because the firmware is not loaded correctly nothing goes right. Does anybody have any suggestions? Should I unmount the daughterboards and do the same procedures again? I _______________________________________________ Discuss-gnuradio mailing list [email protected] http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
