Hi, I have some questions about my rfx2400 board. I was having trouble with some MIMO stuff, so I got pointed in the direction of this note: http://www.gnuradio.org/trac/wiki/USRPClockingNotes and went off to check to see if my board has had the modifications or not.
After looking at the board I'm fairly sure that it came to me already in MIMO mode but I'm asking here just to be 100% certain that my problems are un-related to phase differences. First of all, my RFX board says 'Rev30' on it, I'm not sure that means Rev. 30 or Rev. 3.0; so I looked for the resistor pads that the note says to move. None of the resistors (from or to) are populated, in addition X1 and X101 are also not populated. Finally, the output of side_and_name() (for side A) already lists the board as an "A: RFX2400 MIMO B". To me, all of this says that the board came to me with the phase clocks of the two transmitters aligned for MIMO, is that assumption correct? Thanks Jason _______________________________________________ Discuss-gnuradio mailing list [email protected] http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
