Hi, folks, I just finished building up the code revision 10106 from the svn repository and hooked my my computer. However, my computer won't recognize the USRP2 through its GbE port. The followings are the result I got.
---------------------------------------------------------- [EMAIL PROTECTED]:/workspace/devel/gnuradio/gnuradio-pre3.1.4_r10106/usrp2/host/apps# mii-tool eth0: negotiated 1000baseT-FD flow-control, link ok eth1: negotiated 100baseTx-FD, link ok [EMAIL PROTECTED]:/workspace/devel/gnuradio/gnuradio-pre3.1.4_r10106/usrp2/host/apps# ./find_usrps -e eth0 No USRP2 found. ---------------------------------------------------------- eth0 is the GbE port connected to the USRP2 and eth1 is a FastEthernet card for outer space network connection. I used the txrx.bin file and u2_rev3.bin files in 'http://gnuradio.org/releases/usrp2-bin/trunk/' to burn my SD card as instructed in 'http://gnuradio.org/trac/wiki/USRP2UserFAQ'. The followings are the log I get through the USRP2 serial port when it is turned on. The USRP2 has Basic RX card installed and empty Tx Port and I believe the log is correct in that term. ---------------------------------------------------------- Tx dbid: 0xFFFFFFFF Rx dbid: 0x1 TxRx 00:50:C2:85:30:3F eth link changed: speed = 1000 ---------------------------------------------------------- Is it my computer-side problem? Is there anything I can exam further to narrow down? Best regards, ILKYOUNG _______________________________________________ Discuss-gnuradio mailing list [email protected] http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
