Make sure you put an "M" after the frequency, otherwise it will assume
you want to tune to 100 Hz, which it can't do.
Matt
w w wrote:
So, the board is probally bad....can you recommend a good example
script for testing purposes? I also need the the TVRX board to
Recieve bi-phase L encoded data....is this possible?
Thanks
On Wed, Jan 21, 2009 at 2:53 PM, Eric Blossom <[email protected]
<mailto:[email protected]>> wrote:
On Wed, Jan 21, 2009 at 01:55:32PM -0500, w w wrote:
> Greetings,
> I got the TVRX because I need a board to RX AM from 100 to 600
MHZ. I know
> it is for TV but I thought it could do AM as well. However I
can't seem to
> set the intial freq for the board. Using the same python
script I can set
> the freq for a basic RX board. I don't seem to see any other
errors other
> that then "Failed to set the intial freq". Any suggestions?
Can the TVRX
> board do AM?
>
> Thanks
The TVRX board covers from 50MHz to about 860 MHz.
It doesn't care what the modulation is.
Eric
------------------------------------------------------------------------
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
