Oops! I did nothing other than run the wfm receiver and tried again. It worked!
Steve On Fri, Jan 23, 2009 at 4:24 PM, Steve Glass <[email protected]> wrote: > Hi > > I'm using an RFX400 with my revision 3 USRP. > > After digging through the archive I found that I needed to modify the > RFX400 and then update its EEPROM as described here: > > On Thu, Feb 8, 2007 at 10:18 AM, Matt Ettus <[email protected]> wrote: > >> >> All RFX boards currently shipping are configured for MIMO_B mode, which >> requires a Rev 4 or higher USRP (serial number greater than 500). >> >> If you wish to use it with a USRP with a serial number below 500 you >> will need to do the following: >> >> Remove R115 (zero ohms) and place it at R116 >> Remove R36 (zero ohms) and place it at R34 >> Put the RFX on a USRP (side A) and run the following: >> >> usrp/host/apps/burn-db-eeprom -f -A -t rfxYYYY_mimo_a >> >> where YYYY is the board you have (i.e. 400, 900, 1200, 1800, >> or 2400). >> > > The hardware mods are made but I get an error when I try and set the > daughterboard type using "burn-db-eeprom -f -A -t rfx400_mimo_a" and it says > this: > > Traceback (most recent call last): > File "usrp/host/apps/burn-db-eeprom", line 69, in <module> > 'xcvr2450' : ((XCVR2450_TX, 0x0000), (XCVR2450_RX, > 0x0000)), > NameError: name 'XCVR2450_TX' is not defined > > usrp_print_db.py gives me the following so I am sure side A is the right > side A ;-) > > RX d'board A: Flex 400 Rx MIMO B > RX d'board B: TV Rx > TX d'board A: Flex 400 Tx MIMO B > TX d'board B: <none> > > Any clues? > > Steve > -- The highest human happiness is not the exploitation of the present but the preparation of the future.
_______________________________________________ Discuss-gnuradio mailing list [email protected] http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
