Hi Johnathan,
I'm modifying the gr-sounder project to transmit a 113-bit legendre sequence of the bandwith 32kHz and upconvert to certain frequency in the range 1MHz to 20MHz. At receiver side, the received signal is downconverted to baseband and store the received sequence into a data file. The daughterbaord I'm using is LFTX/LFRX. I modified the FPGA configuration by using clk_divider to downconvert the mater_clock, clk64 to 32kHz, and applied the 32kHz to module adc_interface, sounder,rx_buffer, dac_interface instead of clk64. The other modules still keep the chip-rate(clk64) as the working frequency. At the receiver side, I got rid of the correlation part, made the receiver directly store the received data into rx_buffer. The result shows some USRP overrun signs (uO), and the received data is as shown below: -1 - 1i -1 + 0i 0 + 0i 0 + 0i 0 + 0i 0 - 1i -1 - 1i -1 - 1i -1 - 1i 0 + 0i 0 + 0i 0 + 0i 0 + 0i -1 - 1i -1 - 1i -1 - 1i -1 + 0i 0 + 0i 0 + 0i 0 + 0i However, the frequency of baseband data should be 32kHz, which doesn't exceed the maximum USB data rate 8MHz, why the USRP overrun? The received data should be the amplitude of the code, 4096, and the data should be real part only. What is the possible reason why the received data is as the shown. Thank you so much! Regards, Yan
<<attachment: ynie3.vcf>>
_______________________________________________ Discuss-gnuradio mailing list [email protected] http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
