Did you mean the tune frequency in the basic Rx same with the frequency that i can set in the usrp source block ? So if the same i set the frequency in the usrp source block(from my understand is nco frequency ) equal 1.5Mhz and the tones of the FFT sink seem like the product of the multiplication of the input signal(1.5Mhz) and nco signal(1.5Mhz) and showed only the input signal - nco signal ' s frequency response and i think it's correct.
Yes, if the tune frequency in the usrp source is 1.5 MHz, then the DDC will shift input by -1.5 MHz. Therefore, the tone from the signal generator should be at zero Hz (baseband). However, life is not perfect, and you will have a small offset which is the sinusoid you see in the scope sink.
and i have another question that is the signal that come from usrp source that show in the scope sink show the I and Q signal but if i connect the usrp source with the FFT sink it's show the frequncy response only one graph So i'm not sure what was the FFT sink show(I and Q , just I or Q only , or I +Q )
The FFT is complex, and uses I and Q as complex numbers. Notice that the FFT plot is not symmetric.
The scope plots a real signal vs time, and therefore it uses I and Q as 2 real channels.
-josh _______________________________________________ Discuss-gnuradio mailing list [email protected] http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
