On 10/05/2010 04:30 PM, hafiz zimran wrote: > Hi > We have received USRP2 with WBX and LP0926 PCB Antenna on 19 August,2010. > We are trying to receive GSM spectrum ( Above 900MHz) but we are > getting the error USRP2: Channel 0 not receiving > USRP2: rx_samples(0 failed. > > When we run the command sudo usrp2_fft.py -f 900M , we are getting the > same error. > Below 900MHz, the above mentioned command is working ( we are able to > see the spectrum). > Would you please guide us what the reason for error. > > Best Regards > > Zimran Rafique > > > > > > _______________________________________________ > Discuss-gnuradio mailing list > [email protected] > http://lists.gnu.org/mailman/listinfo/discuss-gnuradio > Are you running the as-shipped firmware? If so, it doesn't support the WBX. You'll need to go here, and get the appropriate firmware and fpga load:
http://code.ettus.com/redmine/ettus/projects/public/wiki/U2binaries -- Principal Investigator Shirleys Bay Radio Astronomy Consortium http://www.sbrac.org
_______________________________________________ Discuss-gnuradio mailing list [email protected] http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
