On 12/01/2010 05:49 AM, Vladutzzz wrote: > Thank you Marcus, for the very prompt and exhaustive reply! > Mostly it's what I expected, but I am a wee bit worried about the IP > addressing process: > I need to change the IP of one of the USRP2 modules, how do I do that, > considering I use an UDP FPGA image and not UHD? > Also, what IPs should I use in the USPR2 source blocks, now that there's 2 > of them? > Thanks! > > Vlad. > My advice would be to screw up your courage, bite the bullet, and convert to UHD.
Theres a UHD utility, usrp2_addr_burner that can be used to change the IP address. The factory address is: 192.168.10.2, you'll need to change it to an address on a different subnet, like 192.168.20.2 or some such. The idea is that you have two GiGE ethernet ports, and you configure your system with the appropriate subnet on each ethernet port, and program your USRP2 addresses accordingly. -- Principal Investigator Shirleys Bay Radio Astronomy Consortium http://www.sbrac.org _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
