Hi everyone, I recently compiled and installed gnuradio.
I then tried to find the usrp2: #find_usrps 00:50:c2:85::3b:5c hw_rev = 0x0400 Next I tried to plot an FFT of the GPS L1 signal (note that my daughterboard is a dbsrx2) #usrp2_fft.py -f 1.57542G usrp2: channel 0 not receiving usrp2::rx_samples() fail Where am I going wrong? I have seen other posts with people facing the same problem but they are from way back in mid-2010 and with different daughterboards from mine. Additional information: - daughterboard is a dbsrx2 - usrp2 was ordered sometime in October 2010 - I have the uhd driver installed but figured that it can exist with the "usual" Ethernet driver - Are there any firmware and/or fpga upgrades I am supposed to make? Nick
_______________________________________________ Discuss-gnuradio mailing list [email protected] http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
