Hi,
is it possible to generate a PPM signal with GNU Radio + USRP2 with a
bit rate of 1MBit/s?
In particular, I want to transmit Mode-S replies which are modulated
using PPM on 1090Mhz. In order to do so, I have to send 0.5µs wide
pulses with time-shifts of 0 µs or 0.5 µs.
The generation of samples on the host is of course no problem, and also
the 1Gbit link to the SDR should suffice to transfer e.g. 4
samples/pulse. The question now is, whether the hardware (USRP2 + WBX
Rev 2) is fast and accurate enough to produce the correct RF-signal.
I played a bit with 2 USRPs, the XCVR2400 (one as sender, one as
receiver) and GRC but I wasn't able to generate a nice square-signal
with a frequency of 1Ghz which would be very similar to the one I need.
So I would appreciate any thoughts, ideas and suggestions.
Matthias
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
