Hi Marcus,
I have not changed the fpga firmware. I used the
build-gnuradio script to install gnuradio. I am not finding another
ethernet cable in the lab. I will check that and let you know in some hours.
My ethernet card in laptop is rtl 8101e. I checked that it is capable of
only 100 Mbps. But here i am using a gigabit switch, so it shouldn't be a
problem right. How should i check if my ethernet port is managed by
netmanager with dhcp support? In my network connections it says auto eth0
for ethernet
On Fri, Dec 28, 2012 at 6:42 PM, Marcus D. Leech <[email protected]> wrote:
>
>> I am getting the following output..
>>
>>
>> karan@karan-laptop:/usr/local/**bin$ uhd_usrp_probe --args
>> "addr=192.168.10.2"
>> linux; GNU C++ version 4.4.3; Boost_104000; UHD_003.005.000-8-g49193c85
>>
>> Error: LookupError: KeyError: No devices found for ----->
>> Device Address:
>> addr: 192.168.10.2
>>
>> how i connected the setup is I powered my usrp n200 with the power cord.
>> I connected an ethernet cable from usrp ethernet port to a gigabit
>> ethernet switch and from the switch i am connecting an ethernet cable to my
>> laptop's ethernet port.I also tried to connect the ethernet cable directly
>> from usrp to my laptop. .It didn't change. Is it ok if ifconfig eth0 says
>> Rx packets as 0?
>>
>> Have you changed the FPGA/Firmware on the device? Are you sure that
> your host ethernet port isn't being managed by Netmanager with DHCP support?
> That will screw up up.
>
> Have you tried a different Ethernet cable?
>
> Is your laptop ethernet port 1GiGe capable?
>
>
>
>
>
> --
> Marcus Leech
> Principal Investigator
> Shirleys Bay Radio Astronomy Consortium
> http://www.sbrac.org
>
>
>
--
Regards
Karan Talasila
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
