Hi, I have two USRP N210s. The sender's "Tx/Rx" port is connected to the receiver's "Rx2" port and vice-versa (via RF-cable). I have a python app running on the sender and receiver which sends a REQ packet to the receiver. I see that the sender receives its own packet. In this app, the receiver is supposed to send an ACK packet when it receives the REQ packets. So, on both the USRPs, the rx and tx paths are set up.
Is the problem occurring because the sender is transmitting on the "Tx/Rx" port and the rx path is valid when the transmission is happening? If so, how do I switch off the rx path while transmitting (is there a uhd API routine for that?)? Any insight will be really helpful. thanks and regards --Anirudh Sahoo Advanced Network Technology Div. National Institute of Standards and Technology (NIST) 100 Bureau Drive, Gaithersburg, MD - 20878 Room - B230, bldg.- 222 Phone- 301-975-4439
_______________________________________________ Discuss-gnuradio mailing list [email protected] https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
