The MTU will only tell you if there is fragmentation. In packet
switched networks, there can be delays for any number of reasons that
are not entirely predictable. For example, assume someone is watching a
video, using VOIP, downloading, etc. These can place heavy load on a
switch, router or hub and saturate buffers delaying your packets and
reducing throughput. Other factors such as QoS or traffic shaping can
alter things. Then you have cosmic rays, bad wires, failing circuitry,
etc. Then on a PC the network stack itself can be a source of delays as
this is implemented in software a dependent on the scheduler and what
else is happening in the machine.
Trying to monitor all this, only places additional load on these systems a
skews your results.
The
best you can do is attempt to define an average and identify the worst
case scenario. Aiming between these two figures will normally provide
you with a robust service that exceeds expectation.
Regards,
Mark McCarron
Date: Tue, 30 Apr 2013 12:40:07 -0700
From: engrsajjadsaf...@yahoo.com
Subject: Re: [Discuss-gnuradio] Calculating the delay of TCP link.
To: mark.mccar...@live.co.uk
Hi,Is it any way to calculate using the MTU size of TCP packet and the sampling
rate, like a mathematical approach using formulas.
Best Regards,SAJJAD SAFDAR
From: Mark McCarron <mark.mccar...@live.co.uk>
To: Sajjad Safdar <engrsajjadsaf...@yahoo.com>
Sent: Tuesday, April 30, 2013 12:33 AM
Subject: RE: [Discuss-gnuradio] Calculating the delay of TCP link.
Calculating delay is complex.
If you just want to know the average time between hosts on an IP network, then
use the Ping command. It has a RTT value in ms. Just remember that on a
packet switched network, this can vary but is typically under 1ms in a local
environment.
Similar delays exist throughout the receive chain and processor, which are
virtually impossible to measure accurately.
Accurate measurements like for radar, or bearings are impossible without some
form of time-stamp at the receiver and that would require an atomic clock chip.
Regards,
Mark McCarron
Date: Mon, 29 Apr 2013 12:01:57 -0700
From: engrsajjadsaf...@yahoo.com
To: discuss-gnuradio@gnu.org
Subject: [Discuss-gnuradio] Calculating the delay of TCP link.
Hi,I am sending audio at 50 kHz sample rate via TCP sink from host A to other
host B. The host B is connected via router in same network. How can i calculate
the time delay from host A to host B via this TCP link.
Best Regards,SAJJAD SAFDAR
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
