How can I set the sampling rate on both ends to be the same? FCDPP sampling rate is 192 KHz.
If I include an audio sink, is the rate of the flowgraph controlled by the sound card sampling rate? Attached are my .grc files. On Thu, Aug 8, 2013 at 11:34 PM, Alexey Bazhin <[email protected]> wrote: > Do you set sampling rate 192000 on both ends? Post your grc files. > > On Thu, 8 Aug 2013 14:09:42 +1000 > Vanush Vaswani <[email protected]> wrote: > > > Hi there, > > > > I'm trying to stream the FCDPP over UDP to a another computer > > The setup is as follows > > > > FCDPP Source -> UDP Sink > > > > For the receiver, > > > > UDP Source -> LPF -> Quadrature demod -> FM Deemph -> LPF -> Audio > > sink > > > > Unfortunately, when I run the flowgraph on the receiver end, I only > > hear a bunch of clicks. > > The console is full of messages "WARN: Too much data; dropping > > packet.". WX GUI FFT Sink and Waterfall seem to work, though with the > > same messages. > > > > Any hints to rectify this issue? > > > -- > Alexey Bazhin <[email protected]> >
udp_rcv.grc
Description: Binary data
udp_send.grc
Description: Binary data
_______________________________________________ Discuss-gnuradio mailing list [email protected] https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
