David hangs up his network cable and sighs..
"yeah, power cycle it, like it says after burning! "
Sorry,
Thanks All.
On 30/06/14 20:31, Ben Hilburn wrote:
David -
Be sure to wait until the burner utility TELLS YOU IT IS COMPLETE.
If you power-cycle in the middle of the burn, it's a great way to
brick your device. If you have bricked your X300, you can recover it
using the JTAG port on the front panel.
Cheers,
Ben
On Sun, Jun 29, 2014 at 7:45 AM, Marcus D. Leech <[email protected]
<mailto:[email protected]>> wrote:
On 06/29/2014 08:51 AM, David Miller wrote:
Hi,
So I boot off of the Live DVD (3.7.4), and try GRC with an
X310 and get an error about the firmware version being 3, when
4 was expected.
I then use usrp_x3xx_fpga_burner to update the firmware, which
after a few minutes of updating, I still get the same error
with GRC?
What am I doing wrong, is there a different firmware update
required, or is the DVD version wrong, please?
Thanks,
David
_______________________________________________
Discuss-gnuradio mailing list
[email protected] <mailto:[email protected]>
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
Did you power-cycle the device after updating the firmware? The
contents of flash are loaded into the FPGA on a reset, which happens
at power-cycle, just like N2xx as far as I know.
--
Marcus Leech
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
http://www.sbrac.org
_______________________________________________
Discuss-gnuradio mailing list
[email protected] <mailto:[email protected]>
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
