On 10/29/2014 09:32 PM, Richard Bell wrote: > Thanks Martin, but I'm still unsure of this process. > > 1) I tried using ./pybombs update, but it doesn't look like it initiated > a build process on anything. Did you mean to imply it would do that, or > just the git pull process for gnuradio and uhd?
Hm, I thought that's what it would do. Maybe it just git pulls. > 2) There is no build directory in uhd, like there was in gnuradio. From > the pybombs/src/uhd directory where do I need to be to execute make and > sudo make install? You sure? Maybe pybombs/src/uhd/host/build ? > 3) There is also no build directory in pybombs, where should I execute > make and sudo make install? That you just git pull. It's pure Python, and doesn't get installed, so it just needs a build process. M > > Thanks, > Rich > > > On Wed, Oct 29, 2014 at 1:18 PM, Martin Braun <[email protected] > <mailto:[email protected]>> wrote: > > Sometimes it's safer to clear the build dir, usually it's OK to leave > in. If you have any cmake variables set, you'll need to reset them if > you clear the dir. > > UHD is updated the same way. In all cases, it depends where you > installed your stuff. > > pybombs can do all this for you, by the way: ./pybombs update > > ...although I don't think this will update pybombs itself. > > M > > On 10/29/2014 08:53 PM, Richard Bell wrote: > > Hi all, > > > > I am new to all of this, so I'm looking for some guidance. I recently > > setup UHD and GNURadio using PyBOMBS on Ubuntu 14.04. I now want to do a > > git pull and update my stuff. I'm not sure what commands to execute > > after I do the git pull for each. > > > > For example, I found two different recommendations for updating gnuradio > > after a git pull > > > > First way: > > > > *git pull > > * > > *rm -Rf build > > * > > *mkdir build > > * > > *cd build > > * > > *cmake ../ > > * > > *make > > * > > *sudo make install* > > > > Second way: > > > > *git pull > > * > > *cd build > > * > > *make > > * > > *sudo make install* > > > > Is the removal of the existing build directory and cmake command > necessary? > > > > After executing git pull, what directory do I need to go to and commands > > do I need to run for PyBOMBS and UHD? > > > > v/r, > > Rich > > > > > > _______________________________________________ > > Discuss-gnuradio mailing list > > [email protected] <mailto:[email protected]> > > https://lists.gnu.org/mailman/listinfo/discuss-gnuradio > > > > > _______________________________________________ > Discuss-gnuradio mailing list > [email protected] <mailto:[email protected]> > https://lists.gnu.org/mailman/listinfo/discuss-gnuradio > > _______________________________________________ Discuss-gnuradio mailing list [email protected] https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
