On 12/16/2014 12:24 AM, Thesis 2015 wrote:
*Good day,*
*
*
*We are beginners using the USRP1 with WBX v.3 50-2200 daughterboard
and GNU radio Companion version 3.7.5.1 with
UHD_003.008.000-18-g864f84b5 installed on Ubuntu 14.04 LTS operating
system. Our goal in using these is to create an SDR WBFM receiver.
We have followed what was done in the video posted by the ettus
research
(http://www.ettus.com/kb/detail/sdr-for-beginners-building-an-fm-receiver-with-the-usrp-and-gnu-radio)
but have encountered some problems. As we ran the GRC file, both the
FFT plot and Scope plot appeared but all we could hear are static
sounds together with the script shown below:*
Executing: "/media/thesis/Data/Downloads/Thesis/FM Reciever using
GRC/fm_example.py"
linux; GNU C++ version 4.8.2; Boost_105400; UHD_003.008.000-18-g864f84b5
Using Volk machine: sse4_1_64_orc
-- Opening a USRP1 device...
-- Using FPGA clock rate of 64.000000MHz...
UHD Warning:
The hardware does not support the requested RX sample rate:
Target sample rate: 5.000000 MSps
Actual sample rate: 5.333333 MSps
-- Tune Request: 88.100000 MHz
-- The RF LO does not support the requested frequency:
-- Requested LO Frequency: 88.100000 MHz
-- RF LO Result: 88.099634 MHz
-- Attempted to use the DSP to reach the requested frequency:
-- Desired DSP Frequency: -0.000366 MHz
-- DSP Result: -0.000366 MHz
-- Successfully tuned to 88.100000 MHz
--
INFO: Audio sink arch: alsa
OOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOO
>>> Done
*As we are doing all the simulations, we did not use any antenna yet.
However, we are waiting for the arrival of the antenna LP0410 400 MHz
to 1 GHz Log Periodic PCB directional antenna, at 5-6dBi Gain. We have
purchased this antenna for it is capable to receive signals from
88.1MHz to 107.9MHz (frequency range of all the FM stations that we
are about to receive).*
*
*
*-SKA15-*
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
The example is designed for an N200/N210, for which a 5Msps sample-rate
is legal.
On the USRP1, the master-clock is at 64MHz, so you can't produce 5Msps
from that, since that isn't an integer fraction of the master-clock rate.
Re-jig the graph to use 4Msps as the input sample-rate. Pay attention
to parts of the graph where it interpolates or re-samples, and make certain
that re-sampling will still work with a 4Msps sample-rate.
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
