Hi Sanjoy,
On 21.07.2015 00:40, Sanjoy Basak wrote:
Dear Mr. Marcus,
I need some help regarding MIMO phase sync. I asked you previously
about the time sync issue for MIMO (2 * 2) on ruby forum.
To say this clear and loud: ruby forum is **NOT** the GNU Radio discuss
mailing list. I urge you to not use ruby-forum but to directly write
mails to the mailing list.
Ruby forum was never, and will never, be the official way of discussion
with the mailing list; GNU Radio and the ruby forum are totally
unaffiliated. In fact, it's much less comfortable than e.g. subscribing
to the list directly with a gmail account:
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
The time sync worked perfectly after checking the next_pps as you
suggested.
That's a good thing to hear!
My problem now is the phase sync between 2 RX signals. According to
the concept, if I initiate set_center_freq after timing command, then
I am supposed to get time aligned and phase aligned RX signals.
Regarding time alignment, I am getting time aligned RX signals.
However, I am not really getting any phase alignment.
The question whether the phase differences will be static depends on
your daughterboard, as explained in
http://files.ettus.com/manual/page_sync.html#sync_phase
This is how I defined for 2 TX 2RX where TXs are on GPSDO and RXs are
on external ref.
self.usrp_source0.set_time_next_pps(uhd.time_spec_t(0.0))
self.usrp_sink0.set_time_next_pps(uhd.time_spec_t(0.0))
Sanjoy, I told you *three* times now to get rid of all the "set_time_*"
calls. I'm getting a little tired of telling you to remove these lines.
You use the time coming from the GPSDO automatically.
now = self.usrp_source0.get_time_now()
starttime = now + uhd.time_spec(1.5)
self.usrp_source0.set_start_time(starttime)
I've told you in my last mail to use set_command_time(). You didn't. You
have to!
self.usrp_source0.set_center_freq(f, 0)
self.usrp_source0.set_center_freq(f, 1)
self.usrp_sink0.set_start_time(starttime)
the same :)
self.usrp_sink0.set_center_freq(f, 0)
self.usrp_sink0.set_center_freq(f, 1)
Could you please tell me what exactly is going wrong or what is the
mistake? I am not really understanding why this should not work.
You're not following clear advice. Please carefully read my last emails,
and my responses on StackOverflow.
I think this might actually happen because instead of using the mailing
list with your email address, you, for some reason, use ruby forum's
html mirror. It's really not good. don't do that.
Best regards,
Marcus
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
