Dear All,
When I increase my packet length in a transmission flow graph to over 16,000 bits, I get the following error "ERROR: send error:send_to: Message too long?" this is from the UDP block which I am using in order to send the transmitted bits to the destination in order to perform BER. I am sending the packets in bursts, one packet every two seconds. I currently have the Payload size set to 147.2k and Send Null Pkt as EOF set to true. Is this some fundamental limit, or can I overcome the issue? Regards, David ________________________________ NOTE: The information in this email and any attachments may be confidential and/or legally privileged. This message may be read, copied and used only by the intended recipient. If you are not the intended recipient, please destroy this message, delete any copies held on your system and notify the sender immediately. Toshiba Research Europe Limited, registered in England and Wales (2519556). Registered Office 208 Cambridge Science Park, Milton Road, Cambridge CB4 0GZ, England. Web: www.toshiba.eu/research/trl --------------------------------------------------------------------------------------- This email has been scanned for email related threats and delivered safely by Mimecast. For more information please visit http://www.mimecast.com ---------------------------------------------------------------------------------------
_______________________________________________ Discuss-gnuradio mailing list [email protected] https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
