Hello everyone, i am new to the world of SDR. I currently have two USRP B200 radios. I would like to connect the Tx port of one SDR to Rx port of second SDR using a cable to visualize the transmitted bits.
I am generating random bits with Ts=1/10000 and 50 samples per frame. Using a rectangular pulse shaping with 20 pulse length ....it would output me a samples with data rate of 200KHz. I am transmitting the baseband signal with gain of 8 and interpoaltion factor 512 over a 432e6 frequency. now i want to visualize the signal by receiving it on another B200 radio . I receive complete noise irrespective of whether i am transmitting (or) not. So can i connect the two B200 radios using a cable so as to see the clean recevieed spectrum.. In this case I believe i should use a attenuator in between the cables.Can you please point more on this ? can i drectly connect without an attenuator?? Ash undergrad student,
_______________________________________________ Discuss-gnuradio mailing list [email protected] https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
