Craig, you might just want to read the files into Python and then use vector sources to generate any kind of signal you like.
Cheers, M On 08/18/2016 07:49 AM, Swanson, Craig wrote: > ​Marcus, > > I have two file sources: pulse and no pulse (noise) > > > I want to use an interleaver to send a pulse file and then after that > just noise. > > But the interleaver will alternate file sources evenly. > > > I want to setup a parameter that allows the combination to vary. Maybe > one time send five pulses, then three no pulses. Then when I run the > python file again, send two pulses alternating with five no pulses. > > > Do you have a block like that? > > > Craig > > > *Craig F. Swanson* > */Research Engineer II > /* > */Information and Communications Laboratory/* > */Communications, Systems, and Spectrum Division/* > /Georgia Tech Research Institute/ > /Room 560 > 250 14th St NW > / > /Atlanta, GA 30318/ > /Cell: 770.298.9156/ > http://www.gtri.gatech.edu > <https://mail.gtri.gatech.edu/owa/redir.aspx?C=c20925f2f0af4dd29329ddf0701ecfff&URL=http%3a%2f%2fwww.gtri.gatech.edu%2f> > > _______________________________________________ Discuss-gnuradio mailing list [email protected] https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
