Jeff, The freq block is an OOT module. I didn’t think they had a GRC file.
Jim From: Jeff Long Sent: Wednesday, September 27, 2023 4:13 PM To: GNURadio Discussion List Subject: Re: Index Error: output_index < noutputs I replaced the Transmit_CESSB block with a Noise Source and Throttle to make a valid flowgraph. Did you mean to send freq.grc instead of freq.py? Disabled that block in the top level flowgraph. In any case, no errors when running the flowgraph. When I hit PTT, I see noise, and otherwise nothing (no audio being played). The wave_select code seems to be right. It's set to a static "0" at the top level and that carries through to the hier block. This is on the latest maint-3.10 code. I don't have a 3.9 installation sitting around. There was a recent behavior change in this block, but nothing that should cause the error message you are seeing. I did replace the Wav File Sink blocks in FT8 Receive with Null Sinks for testing, so you might want to do that just to check. On Wed, Sep 27, 2023 at 2:09 PM Elmore Family <wa4...@comcast.net> wrote: Jeff, I have attached the top level GRC (softrock_QT.grc), the Receive.grc hier block (feeds the stream to the FT8_Receive block) and freq.py (the OOT module containing the code that I am questioning). The Transmit hier block is not pertinent to this discussion. Note that this is a fully functioning SSB transceiver that I have had on the air. I am attempting to add the digital mode FT8 to it using the FT8_Receive block along with some additional code in the freq.py file. Jim From: Jeff Long Sent: Wednesday, September 27, 2023 12:18 PM To: GNURadio Discussion List Subject: Re: Index Error: output_index < noutputs Sorry, it takes too much time to make guesses from fragments of a project. Could you post a grc file that is runnable and shows the error? On Wed, Sep 27, 2023 at 11:14 AM Elmore Family <wa4...@comcast.net> wrote: Marcus, I forgot to include the version: 3.9.4.0. Jeff Ignore the previous GRC with the Python block. I did things differently this time as you can see in the connections. I also attached the FT8_Receive.grc file. Jim -----Original Message----- From: Marcus Müller Sent: Wednesday, September 27, 2023 6:00 AM To: discuss-gnuradio@gnu.org ; Elmore Family Subject: Re: Index Error: output_index < noutputs Hi Jim, since we've worked on Selector recently, it would **really** be important to know the version of GNU Radio you're dealing with! Best regards, Marcus -- This email has been checked for viruses by AVG antivirus software. www.avg.com Virus-free.www.avg.com