On Wed, Nov 5, 2014 at 2:36 PM, Dan McDonald <[email protected]> wrote:
> > > On Nov 5, 2014, at 3:31 PM, Schweiss, Chip via illumos-discuss < > [email protected]> wrote: > > > > I had a system crash this morning when I/O on a pool was hung with > failmode=panic. > > What version of OmniOS are you running? > r1510010 > > > That was 7 1/2 hours ago and it's at 64%. I'm going to let it > complete so the failure can be analyzed more, but I really need to find a > way to significantly speed up the crash dumps. > > > > This system has 256GB ram and a dedicated dump pool of two 320GB > mirrored SATA disks. > > > > I'm aware of the multi-threaded dump issue so I have these to lines in > /etc/system > > > > set dump_plat_mincpu=0 > > That should be the default now. I can't remember which rev of OmniOS it > showed up in, but certainly it's in 010 or later. > > > It's not clear where the bottleneck is. I don't think it's the disk. > The disk activity lights are a light flicker, by no means being hit hard. > Unless it's a serial latency issue. > > > > What would be my best approach to get good dumps from a system like this > in minutes, not hours? Assuming that is possible. > > You weren't dumping to the same pool or the same controller where you had > the I/O hang, were you? > No, I setup a dedicated dump pool to a pair of mirrored SATA disks connected to the motherboard AHCI controller. -Chip > > Dan > > ------------------------------------------- illumos-discuss Archives: https://www.listbox.com/member/archive/182180/=now RSS Feed: https://www.listbox.com/member/archive/rss/182180/21175430-2e6923be Modify Your Subscription: https://www.listbox.com/member/?member_id=21175430&id_secret=21175430-6a77cda4 Powered by Listbox: http://www.listbox.com
