I just put in this fix this afternoon. I used 33pF, 0805-size caps (forgot to check the dielectric type; they may have been X7R. I can check and get back to you if you care about that). Anyway, it does dramatically reduce the noise, but in my case, does not eliminate it. With the headphone cord in the position I described in my 7/15 post, i.e. across the bottom center of the SB2, there is still audible buzzing or clicking in wireless mode.
Just curious: how did you determine the 33pF value? By the way, I really don't care about the little bit of noise; I don't expect I'll use the headphones much at all, and when I do, I'll be careful where the headphone cord goes. This is just a data point for you and others. seanadams Wrote: > Anyway, the fix is pretty simple but it does require soldering: attach > two 33pF caps to ground on the headphone jack - make sure to keep the > leads as short as possible - surface mount caps are best. This > eliminates the problem for my test case, irrespective of antenna > arrangement etc. -- Dave D _______________________________________________ Discuss mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/discuss
