ralphy;562350 Wrote: > I don't think so. > > Device 0 should be "almost" direct access to the pcm device whereas the > others have additional processing overhead. That's probably why you're > seeing the higher cpu usage. > > Change line 312 of src/slimaudio/slimaudio_output.c back to it's > original value of zero. Try changing line 291 as follows. > > Code: -------------------- > > > - outputParameters.suggestedLatency = paDeviceInfo->defaultHighOutputLatency; > + outputParameters.suggestedLatency = 0.08; > -------------------- > > > > If you still have drop outs increase this value from 0.08 to 0.085, > 0.09, 0.095 and 1.0
Is it really 1.0 or is it a typo mistake ? because it's very different from 0.095 Anyway, it works ! :) Finally ! I tried 0.08, 0.085, 0.09 and 0.1 but I still had drops. Then I tried 1.0 and it was fine ! I also tried smaller values and found 0.2 was ok. So the the minimum value is probably between 0.1 and 0.2 Is it important to set it to the smallest value ? I can't hear any difference between 0.2 and 1.0, but it only plays through the poor speakers of the laptop at the moment, I'll try with headphones when I'll be back home. Thanks a lot anyway and congratulations for squeezeslave, it's a really good and useful software. -- Antoniop ------------------------------------------------------------------------ Antoniop's Profile: http://forums.slimdevices.com/member.php?userid=39292 View this thread: http://forums.slimdevices.com/showthread.php?t=63966 _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/discuss
