My first post. Rather than start a new thread, this thread seems to be closest to the problem I have.
For a long time, I was under the impression my SB3 remote control was broken, but this didn't matter as I had used a smartphone app to control my SB3 for a while. Then I overhauled my home network and changed from WEP to WPA2. Consequently my SB3 can no longer connect to my home wifi. Now I think the remote is OK. I verified this by starting Photo Booth on my iMac and pointing the remote control at the built in camera. I see a flash when I press buttons on the remote. I also compared this with a known working TV remote control. When I power up the SB3 I see these screens logitech splash screen squeezebox splash screen Welcome to Squeezebox (press right arrow...) Connecting to wireless network... Then the screen goes blank. I tried all 4 tests here http://wiki.slimdevices.com/index.php/Special_IR_Keys_on_Reboot_for_Factory_Reset_and_Last_FW but the remote control was ignored. I tried Net::UDAP via an ethernet cable, but Net::UDAP doesn't discover the device. No sign of the MAC Address. Also I wasn't sure if an SB3 is the same as a SB Receiver. I don't need wireless as I have an ethernet switch nearby. If I open the thing, can I cause a factory reset, which might allow me to configure it via Net::UDAP? Or is there some other route I can go down? Suggestions are welcome! Cheers, BoB ------------------------------------------------------------------------ Beast Of Bodmin's Profile: http://forums.slimdevices.com/member.php?userid=11031 View this thread: http://forums.slimdevices.com/showthread.php?t=98840 _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/discuss
