>>>>> w3wilkes <[email protected]>:
> A couple of basic questions... > Do you have the receiver Ethernet attached? This is required. Yep. > Did you factory reset the receiver after you Ethernet attached it? No. I didn't know how. > To factory reset hold the front button until you get a fast red blink. Now I know how...! Thank you! :-) I have plugged in the RJ45 cable, plugged the power out and back in, and pressed the plug until the front light blinks red. Then I started Net::UDAP shell, ie. cd ~/git/net-udap ./scripts/udap_shell.pl Then I did the following commands in the UDAP shell: discover conf 1 set interface=0 wireless_mode=0 wireless_region_id=14 wireless_SSID=MySSID wireless_wpa_on=1 wireless_keylen=1 wireless_wpa_psk="Top Secret!" lan_ip_mode=1 squeezecenter_address=192.168.1.150 save_data reset (this time I got no error messages) But the status is still the same :-/ : - The MAC of the SB Duet receiver repeatedly connects to the Access Point - There are no entries for the MAC of the DB Duet receiver in the DHCP server log - The SB Duet Receiver does not show up in my SqueezeCenter I have tried powering off and on the SB Duet receiver (plugging the power out and back in) with the RJ45 cable disconnected, but the SB Duet receiver still hasn't shown up in the DHCP logs or in SqueezeCenter, unfortunately. After powering the SB Duet receiver on, the light first goes red, and then goes white. Was it supposed to end up in a different colour? Green, perhaps? > I've used the Windows Net::UDAP a couple of times and it worked fine > provided I started with the receiver being Ethernet attached and being > in the factory reset state. Yes, when I tried the commands conf 1 set interface=0 wireless_mode=0 wireless_region_id=14 wireless_SSID=MySSID wireless_wpa_on=1 wireless_keylen=1 wireless_wpa_psk="Top Secret!" lan_ip_mode=1 squeezecenter_address=192.168.1.150 save_data reset after having reset the Duet receiver using the front button, there were no error messages containing the text "Uninitialized value ...". So I guess it was the missing reset of the SB Receiver rather than perl version that caused the error messages. But thanks for taking me a bit further! :-) I will read the Net::UDAP documentation more closely to see if there was a step I've missed. _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/discuss
