I can't see what you are seeing (obviously) and in my brain is my old altec lansing computer 2.1 setup , so I went out and found this https://audiomods.datsunzgarage.us/promedia/ is this your system?
If so, it does look like the "preamp" I was referring to is a separate unit below one of the sats. If the sats speaker connections are completely independent of this "preamp" unit, then you are right, signal from the sb to the lipai to the speakers, should work fine :confused: I wouldn't suspect a "weak signal" from your sb if you are at 100% volume, also, make sure you don't have any of the replay gain settings on. All of these devices are "line level" and while some are "hotter" than others, it would not contribute to what you are hearing. Here's an experiment - hook the sb into the avr (make sure all of the sound processing is off, you want "stereo", direct if it's available). connect a fm antenna, Hook a tape monitor (out) into the lipai. Then you should be able switch between FM and the SB and compare volume through the lipai. Instead of fm if you have a cd player, etc... be careful if you try the sb->lepai**->klipsch 12"** as you will have two preamps/crossovers in the signal path (the **). I also happen to have an old klipsch ksw12 sub, it has line in and line out, so (if you have the same or similar) you could hook the sb directly into 12" sub. Maybe try to run the little sats from the 12" then? If you wanted, you could go sb->12" line in, 12" line out -> lepai line in, not sure what they would get you tho... with these problems I always try to swap things around to isolate the problem, as I have alot of old legacy stuff laying around. ------------------------------------------------------------------------ Redrum's Profile: http://forums.slimdevices.com/member.php?userid=33806 View this thread: http://forums.slimdevices.com/showthread.php?t=113854 _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/discuss
