It sounds like the SB3 is being more picky about the quality of the connection. There has been some discussion to this affect on the forums over the last couple of weeks or so. It probably isn't aut-negotiating down to 10mbps for a more stable connection (the old SB1 had only a 10base-t card). If your long run (10m) was home-made you might try re-crimping the ends. Sloppy crimping with lots of untwisted wires at either end can cause a poor connection. Alternatively, you could try picking up a cheap switch and putting it at the end of your long cable run near the SB3. It might be able to handle the auto-negotiation better over your poor cable run, then the SB3 could connect to the switch over a short, high-quality run.
_______________________________________________ Discuss mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/discuss
