D'oh...anyone have a rock with a geek-sized hollow underneath? Thanks Ben, I pushed just a bit harder and it wasn't as solid as it first felt.
I guess I was being too gentle. The SB3's thin upper edge also doesn't give you much of a surface to stabilize so that you can push on it as hard as you have to. --- Ben Sandee <[EMAIL PROTECTED]> wrote: > On 1/10/06, Mark Lanctot > <[EMAIL PROTECTED]> > wrote: > > > > > > My headphones (old Sony CD250s) worked fine on my > SB2. > > > > However the plug does not fit in the socket on my > new SB3? > > > > I assume there must have been a part change. > Suddenly the plug bottoms > > out with 1/8" to go. I can only make contact with > the L headphone > > output - if I back it out I briefly get R output, > but I can no longer > > get both at the same time. > > > > > Are you absolutely sure that the socket isn't just > tighter than you > expect? My headphone jack on my SB3 is very tight > and if I didn't know > better I would have through I was going to do some > damage pushing it in that > last 2mm. > > Ben > > _______________________________________________ > Discuss mailing list > [email protected] > http://lists.slimdevices.com/lists/listinfo/discuss > __________________________________________________________ Find your next car at http://autos.yahoo.ca _______________________________________________ Discuss mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/discuss
