richidoo Wrote: > > I measured across one analog output with 0dB test tones playing at SQB > volume setting 40 through entire freq band. V read .4V and gradually > decreased to .09V and falling. Then I realized I was giving the SQB no > resistance to drive, so the readings are BS. Can I just hang a 100K > resistor in series and measure the output voltage across signal and > ground of analog out? > > Anoyone ever measured SQB output? > Thank you > Rich
Make sure you really have a full-scale test tone. There is a built-in test tone which I am certain is correct (reboot and press 3 on the splash screen) which may be helpful. You should see 2V rms. A load resistance is not needed. -- seanadams ------------------------------------------------------------------------ seanadams's Profile: http://forums.slimdevices.com/member.php?userid=3 View this thread: http://forums.slimdevices.com/showthread.php?t=19960 _______________________________________________ Discuss mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/discuss
