Well, I *tentatively* think the answer was behind door number 3. It's
been about 4-5 hours since I pulled the wireless card out, and the SB1
has stayed up. Recently, it would have shut off by now, so I'm hopeful
that this solved it.
For future reference, what exactly is the TOSLINK LED?
seanadams wrote:
At this point you should probably contact support, since not responding
to press-and-hold-power means the unit is either wedging itself in some
way or losing power - it probably is not a network issue. I don't have
an especially likely explanation, but a couple things you might try to
narrow it down:
- check the TOSLINK LED. it should be on at all times after startup as
long as the unit is getting power.
- The filaments (thin horizotal wires) in the VFD should be slightly
glowing. If they ever shut off, this is another indicator of a power
supply issue.
- the wireless card may be on the blink or improperly seated - it
shares the memory bus so it's conceivable that it could precipitate a
crash. if you don't need it, try removing it.
--
============================================================================
Chris Egolf
http://www.ugholf.net cegolf [AT] ugholf [DOT] net
============================================================================
_______________________________________________
discuss mailing list
[email protected]
http://lists.slimdevices.com/lists/listinfo/discuss
