Hi all, first time poster, though I've read a lot on these forums since purchasing my Squeezebox v2 in October 2005. I've a problem that is preventing my Squeezebox from connecting via wireless. I've been running SlimServer 6.3.0 for awhile now with firmware revision 55. About five days ago I noticed my Squeezebox wasn't connected to the network. No changes either in the network or the SlimServer occurred. I have not had any power surges that I know of, but regardless I have the Squeezebox powered through a Monster Power HTS 5100.
I began troubleshooting the wireless connection by going through the wireless network settings. * SSID was set to another wireless network, and my SSID was not on the list * I began to enter my SSID manually, but the Squeezebox screen went blank and I had to power cycle the unit. * Magically, my SSID appeared on the network list again. * I moved on to the WPA Personal key, which appeared as all stars. * I re-entered my key, but twice while doing so I received a "malloc failed" notice on screen, followed by a blank screen, then the initial power up "Welcome to Squeezebox" setup screen. * I finally managed to key my key re-entered, but the Squeezebox never would connect with my wireless network. The screen would just go blank after the "Connecting" message displayed for about 5 seconds. * I connnected via Ethernet successfully. * I refreshed the firmware, still on revision 55. * Now the Squeezebox resets every time after choosing the SSID. The screen immediately goes blank after I push the right arrow for the next setup step, then the "Welcome to Squeezebox" initial power up screen displays. * After power cycling the Squeezebox, it tries to connect to the wireless network, but then the screen goes blank within 5 seconds. * I uninstalled SlimServer 6.3.0 and installed 6.3.1. * I reconnected via Ethernet to see if there was a new firmware along with SlimServer 6.3.1. * I didn't see any notices via the web interface, so I again forced the firmware refresh via remote control and it still looks like I'm on revision 55. * The Squeezebox is still exhibiting the same behavior with resets every time I try to connect via wireless or modify my wireless settings past the SSID screen. Not sure what to do here guys. Any ideas? -- haylo75 ------------------------------------------------------------------------ haylo75's Profile: http://forums.slimdevices.com/member.php?userid=7266 View this thread: http://forums.slimdevices.com/showthread.php?t=26970 _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/discuss
