Furry;207462 Wrote: > > Did you measure the inner diameter of the centre hole? I suspect that > even a small difference could cause this problem.
The nominal inside diameter is 2.5mm. I didn't have any proper way to measure it so I used a 3/32 drill bit (2.38125 mm) to "feel" for a difference between the two connectors. It was hard to tell any difference but it felt like there might actually be more play with the Unifive one. The outside I measured with digital calipers and any difference was barely detectable - not more than a couple hundredths of a mm. This is the best I could do with what I have on hand - we'll find out more when our mechanical guys look at it. I don't know why it should be that sensitive - it is after all a pretty simple design that is used in zillions of products. -- seanadams ------------------------------------------------------------------------ seanadams's Profile: http://forums.slimdevices.com/member.php?userid=3 View this thread: http://forums.slimdevices.com/showthread.php?t=35899 _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/discuss
